Multi Ingredient Loader 1.0

The Quattro 1.0 loaders are ideal to install in situations where height is restricted. So the main base loader should be used for the catalyst feed and up to 3 different additives can be blended additionally.

The support frames will handle tote bins (flowbins) of different sizes. The outlet of these bin should be straight down and modified to be used with camlock coupling. So simply put the additive bins on the support frame, connect coupling and operator can type in the required addition rate/day.

Operation is VERY simple. Just give in required daily addition rate and kg per shot for the catalyst. Then enter the daily rate for each additive (connected).
The computer will calculate the injections and make sure the catalyst and additive is evenly injected during the 24 hour. When additive bin is empty a warning is given, but loader will continue with other ingredients. In display of terminal is displayed which ingredient is empty. 

Common plant problems such as pressure failure , blocked FCC lines , filling line problems are included in software and will be self-adjusted as much as possible

Skid is delivered completely assembled and tested for 48 hours before it will leave our shop.

The only connections to be made on site are:

• Install the storage hopper on top of base unit
• Discharge line FCC
• Main air connections
• Main power supply (to main switch)


All Pneumix skids are designed for the hazardous area classification being:

Zone: I
Gas Group II B+H2
Temp. Class: T4

Pressure Vessel:

Test pressure: 15 barg 216 psig
Design pressure 11 barg 160 psig
Operating pressure: 6 barg 87 psig
Design temperature: -20°C / 100°C
Corrosion allowance: 3 mm

More products